Hello Unregistered ,
Hi All, I'm finishing a wall clock using SW2812B NeoPixels strings. The digits are 15cm high and it works fine. But I'm looking for something I could display on much bigger (isn't bigger always...
all bit definitions are in the mpasmx folder *.inc files. the datasheet refers to any timer1 type timer for that chip, ie tmr1 tmr3 tmr5 eg 9788
I have a feeling I'll be waiting a while for that to happen. :D I've brought that down to Ticks > 1. I've started again with the original includes, and: - added 32MHz - changed PIE1 to PIE4 -...
how big would Ticks have to be to make this true ? IF Ticks > 100 THEN
I only wanted 1 interval, so I'd know the mods were working with the 16F18877.
I'm already using Timer1, hence why I hoped to use Timer3. I'll swap what I'm doing, so I can use DT's routine without changing Timer1. (At the restaurant, so can't post elaborate reply)
there are more problems here than i can count 1, timer3 has no clock source 2, how can ticks ever get beyond 100 main: LatB.1 = 1 ' Pulse heartbeat IF Ticks > 100 THEN ...
I would start off with interrupt and in routine just add to a counter then in Basic do the math to get seconds, minutes etc. Otherwise that is a lot of code to fumble through. :eek::cool:
16F18877 I start the timer, but I don't get a pulse on Logic Probe after 100 Ticks. Code: #CONFIG __config _CONFIG1, _FEXTOSC_OFF & _RSTOSC_HFINT32 & _CLKOUTEN_OFF & _CSWEN_OFF &...
I don't see a difference between FSR0 and FSR1. I assume I can use either one? 9786 EDIT: Wooops, highlighted the wrong one, but you get the idea. FSR1 is right there as well, and it points...
HDMI wall projector "interface"
Hi All,
flotulopex Today, 09:55I'm finishing a wall clock using SW2812B NeoPixels strings. The digits are 15cm high and it works fine.
But I'm looking for something I could display on much bigger (isn't bigger always...