Hello Unregistered ,
post the code . no point guessing
I'm not setting anything to tri-state, yet. Using TXSTA.5 = 1 / TXSTA.5 = 0 is just preparing myself for when I will use Usart pins in tri-state. I thought I could just turn Usart TX and RX...
yet when tx is disabled the pin is hard driven to logic 0 , explain how disabling tx-module sets the pin to "tristate"
I'm not using tri-state yet, cause for now I have only two PICs talking, and they're not sharing any lines (but I will be the future, hence why I'd like to master enable/disable of transmitter). ...
explain how disabling tx-module sets the pin to "tristate"
I'm not doing anything to it. Should I?
Hmmm, I moved PIC #2 up in PIC #1 spot, and put in a new unit in PIC #2 spot. PIC#1 can now disable transmitter at will, YAY! So that confirms that there's nothing on the breadboard interfering...
when you disable the transmitter how are you setting the tx pin code ?
IT'S THE DARN PIC ! I swapped the coding between the 2 PICs, and PIC #1 now has a framing error every time it tries to disable the transmitter. 9760 I'm going to swap it for another unit...
PIC #1: TXSTA.5 = 1 ' TXEN: Transmit Enable bit hserout [ "[1]" ] while TXSTA.1 = 0 ' Check TRMT: Transmit Shift...
Re: Framing error if I disable transmitter after shift register is empty?
post the code . no point guessing
richard Today, 01:51