Hello Unregistered ,
Hello, thank you for visiting the picbasic users forum. Just a little note to remind you that, if your have registeted for a user account and you have not logged in and posted a message, unused accounts are deleted from time to time.
We track user account usage. As part of our general maintenaince and to meet the GDPR requirments, we have elected to delete user accounts that are unused.
We define unused as:
NOT haveing ever posted a message on the forum
AND
NOT having logged in for more than 360 days.
If you find that your account is deleted, because of inactivity, you will need to contact the forum administrator to have the account re-instated. email: [email protected]
Paul. Can we see that? I have used pics with the internal CAN module and a can line driver and ones without but with an external microchip mini CAN board and line driver. I built a Honda...
I have been working on a CAN interface file where you pass a few initial set up parameters, speed etc. and it selects and sets the appropriate registers. When you want to send a frame, you load a...
Be interested to see what you were working on. I've done quite a bit on CAN with PBP.
Thanks for the explanation. I misinterpreted these paragraphs. My understanding was to have ASYNC cleared and use Fosc/4. Ioannis
The SYNC block uses FOSC/4 as its sync clock, so it's difficult to use it if it's using FOSC/4 as its input source for counting too. 9966 for 16-bit read/write see sec 20.1.1.1: 9965 In...
Sure it is. Inside the ISR, Timer 0 is stopped, reloaded and restarted. I think is it obligatory to use Fosc/4. Unless I misunderstood the DS. Then why is it necessary to use ASYNC=1? Could...
Two things... Since you're using FOSC/4 as the source, set ASYNC bit in T0CON1. Also, when using 16 bit mode (MD16=1) you should always write TMR0H then TMR0L in that order so that the high...
looks like not reloading the tmr count every ms....... after first int, tmr counter looping from 0 .....???
Tried the files and indeed it worked OK. Sort off... I tried to setup the Timer 0 as 16bit timer, cloked by Fosc/4 with system clock at 64MHz. Reload value $C187 The toggle happens every 4...
Thanks Richard. Ioannis
Menu
Re: CAN header and EXT asm question
Paul. Can we see that?
retepsnikrep Today, 05:26I have used pics with the internal CAN module and a can line driver and ones without but with an external microchip mini CAN board and line driver.
I built a Honda...