Managed to test it and yes. One can count from 0 up to the last port in series for the analog inputs.
Works just fine.
Ioannis
Before dealing with the registers directly, does anyone know what is the sequence, if any, on the analog inputs of the above chip?
I mean, after RA0-RA7 that corrssponds to Analog 0 to Analog 7,...
Plus to what Henrik posted, if you want Pickit2/Pickit3 standalone software, there is also a (paid) version of the old stand alone but now developed and supported by Anobium...
Ioannis Yesterday, 14:04Strange ...
What IDE do you use and which PBP version ???
here, I tested with MPLAB 8.92 and PBP 3.1.6.4 ( last release )
Thanks for the help, however i still can't compile. i just want a HEX. i hope someone can post it. thanks
Galaxy76 - 24th May 2025, 18:19also you can download this one ...
https://support.melabs.com/articles/6151-meconfig
Pretty useful, no ?
Hi,
Replace your @DEVICE ... lines by
;----[12F629 Hardware Configuration]--------------------------------------------
#IF __PROCESSOR__ = "12F629"
#DEFINE MCU_FOUND 1
#CONFIG
Hello, I have this code, but I can't compile it. I always get error. Could someone please compile it and post the hex file here? Thanks
sorry for my english.
@ DEVICE pic12F629,...
Re: Help with Pololu DRV8711 Stepper Motor Driver
OK - Problem solved. I went to Pololu and got help from their tech folks and they helped me figure this out. In a nutshell, it had to do with how I was creating the CTRL and TORQUE registers and...
Atom058 Yesterday, 19:08