Hello Unregistered ,
You are welcome! Ioannis
Thank you I'm glad you're still around I remember you for the early 2000'ns
Change according to your needs. #CONFIG CONFIG OSC = XT ; XT oscillator CONFIG OSCS = OFF ; Oscillator system clock switch option is disabled (main...
I'm changing chips and there is a config file or some file to modify I can't remember what it is or where it is
Thank you Henrik. Its ok now, Ioannis
And of course this explains the periodic error in the LED flashing... Ioannis
Nice catch... When someone shows you the stupid mistakes, its that moment you are embarrased a lot Ioannis
A value of 0 in the pins PPS registers sets it to be controlled by the LAT register. See bottom of table 17-2 in the datasheet.
In the ISR you have this: if seconds<1000 then seconds=seconds+1 else seconds=0 Timer0=0 'Stop timer0 TMR0H=$C1 'Load Timer 0 with start value...
If id does matter, chip is 47K42. After setting the registers for a PWM output and selecting, for example, RC5PPS=%%00001001, the PWM signal indeed does appear on the output port. What about...
Menu
Re: changing from 16f876 to 18f252 file to modify
You are welcome!
Ioannis - 2nd June 2025, 08:27Ioannis