Yes, I already started re-designing the PCB, and discovered that there's an error in datasheet - PIC18F66K80 actually has 52 IO pins, not 54, as stated in the beginning of datasheet!
Well, While that was a problem, it was not THE problem. Still no movement. I tried both mode 1 and mode 0 for the SHIFTOUT methods, also, to no avail.
Here is a snip of the circuit board design...
Hello - I am trying to write a simple program to run a stepper motor back and forth using the Pololu DRV8711 driver (Link: https://www.pololu.com/product/3730). In order to use the driver, you must...
I played with the MCP25625 (CAN controler and driver) using the SPI peripheral on the 18F57Q53 a while back (just looked, turns out it's 4 years ago now, bloody hell...).
My intention was to make a...
Menu
Re: 64 pin 18F series MCU, which operates from 5V and has same pinout as 16F series?
Yes, I already started re-designing the PCB, and discovered that there's an error in datasheet - PIC18F66K80 actually has 52 IO pins, not 54, as stated in the beginning of datasheet!
CuriousOne Today, 05:01