Hello. I need to send ubx commands to change the gps module settings. I copied the sequence from U-Center (B5 62 06 01 08 00 F0 08 00 01 00 00 00 00 08 60) but I can't encode it correctly to send it...
I wanted to give a little update about a machine built and updated over the past few years and say thanks to all the answered questions I had programmatically when I got a little stuck.
A single...
so, I have made a exhaust fan timer with 1 mom button that will.... depending on press duration do..
----- >50ms and < 2seconds..... run fan for the programmed time of 15, 30, 60 or 120 minutes...
Amgen - Thanks for your input. Yes, I have tried both Mode 0 and 1 with no luck. I have also tried reversing the SCS pin (low, shiftout, high as opposed to high, shiftout, low) and nothing there...
Yes, I did set ADCON1 and no, I have not used a scope on this yet. Here is the entire code. I am simply trying to initialize the driver and run a stepper back and forth with 2 LEDs that indicate...
send ubx commands to a gps module
Hello. I need to send ubx commands to change the gps module settings. I copied the sequence from U-Center (B5 62 06 01 08 00 F0 08 00 01 00 00 00 00 08 60) but I can't encode it correctly to send it...
mombasa Today, 10:42