Hello Unregistered ,
Hello, thank you for visiting the picbasic users forum. Just a little note to remind you that, if your have registeted for a user account and you have not logged in and posted a message, unused accounts are deleted from time to time.
We track user account usage. As part of our general maintenaince and to meet the GDPR requirments, we have elected to delete user accounts that are unused.
We define unused as:
NOT haveing ever posted a message on the forum
AND
NOT having logged in for more than 360 days.
If you find that your account is deleted, because of inactivity, you will need to contact the forum administrator to have the account re-instated. email: [email protected]
You are welcome! Ioannis
Thank you I'm glad you're still around I remember you for the early 2000'ns
Change according to your needs. #CONFIG CONFIG OSC = XT ; XT oscillator CONFIG OSCS = OFF ; Oscillator system clock switch option is disabled (main...
I'm changing chips and there is a config file or some file to modify I can't remember what it is or where it is
Thank you Henrik. Its ok now, Ioannis
And of course this explains the periodic error in the LED flashing... Ioannis
Nice catch... When someone shows you the stupid mistakes, its that moment you are embarrased a lot Ioannis
A value of 0 in the pins PPS registers sets it to be controlled by the LAT register. See bottom of table 17-2 in the datasheet.
In the ISR you have this: if seconds<1000 then seconds=seconds+1 else seconds=0 Timer0=0 'Stop timer0 TMR0H=$C1 'Load Timer 0 with start value...
If id does matter, chip is 47K42. After setting the registers for a PWM output and selecting, for example, RC5PPS=%%00001001, the PWM signal indeed does appear on the output port. What about...
Menu
Re: changing from 16f876 to 18f252 file to modify
You are welcome!
Ioannis - 2nd June 2025, 08:27Ioannis