
MenuProblem solved: just needed to run the BATCH file with administrator's rights.
flotulopex Today, 19:03
Greetings HenrikOlsson and Richard,
thank you so much for your help.
I will make a few changes and run some tests to see if I get it running correctly.
@Richard, regarding the osc settings,...
another issue
OSCCON =% 01110010 '8MHz INTOSC OSCTUNE=% 01000000 '
Hi All,
I'd like to launch the compiler/assembler and the PICKit3 programmer, all in COMMAND LINE mode, in a DOS batch file.
Unfortunately, I'm getting error messages at compile/assemble time....
Random ramblings and guesses here, take for what it is:
That's not how it works. The ISR triggers when there's a byte is received. You can't configure it to fire after n character (short of...
Hi Richard,
thanks for the help.
According to the information on the display (when set to show the 4 incoming characters), 2 initial characters are being sent as carriage return (10 and 13)...
yet your rx routine wants 4 chars
HSERIN [RX1, RX2, RX3, rx4]
what is the actual msg you receive [in ascii chrs] is there a start chr how does the msg terminate /n, /CR, /LF?
Hi guys,
I'm facing a weird behaviour with my 18F2580 using Hserin and RX interrupts and I was hoping someone could help.
I'm trying to run a code that when an incoming 2 characters is...

Re: Command Line operation ni a BATCH file
No, still not solved yet :frown:
flotulopex Today, 21:29When the batch file is launched with admin rights (I made a shortcut file to my batch to be able to launch it with admin rights), all HEX, ASM, etc files are not...