If you want to increase trace/via capacity without increasing their size (maybe it complicates the rest of your circuit), just make more.
https://i.imgur.com/DH51l19.png
In my case, the 7805...
Thank a lot Richard. I'll give it a try :wink:
flotulopex Yesterday, 15:30Here's the link for the video again.
https://youtu.be/YlgEs6JWzTg
Sorry, I'm not the YouTube expert so I hope it works now :o
Valuable source of info.
Thanks for sharing,
Ioannis
I found these web pages to better design my PCBs.
Traces:
https://www.mclpcb.com/blog/pcb-trace-width-vs-current-table/
Vias:
...
as has been pointed out many times, use the flash memory
https://www.picbasic.co.uk/forum/showthread.php/24442-Effective-ways-for-storing-multiple-string-variables-within-PBP-code
try this 16 led strip on RC7
' PIC 16F690 @20MHz
#CONFIG
__config _FCMEN_OFF &_IESO_OFF &_CPD_OFF &_WDT_OFF &_HS_OSC &_BOR_OFF &_CP_OFF &_PWRTE_OFF &_MCLRE_OFF
#ENDCONFIG
CLEAR
TRISC...
the youtube link is a dud, but i take it that it works even though the timing is a little out of specs
9695
Here is a copy of the Richards example.
'***************************************************************************
'* Name : ap102.pbp *...
Re: Determining trace/via/wire current capability
Put vias under component. Make bottom copeer pad large, and you have much better heatsink capabilites.
pedja089 Today, 08:35Make via also untinted ut botom, so you can fill it with solder. For my taste your trace to via...