Hello Unregistered ,
hello! Does anyone have a working code for ads1115 (Proton PicBasic)...
Darn tootin' right. It's nice to finally use it as a diagnostic/testing tool. The scope has always been a mystery to me. I've always wanted to use one, but never had any electronics training. ...
What a magic tool Oscilloscope is, right? Ioannis
I wanted to see just how sharp a Schmitt trigger could clean up a signal. This is using a MR0102 with rocker actuator, followed by the Bourns RC debounce circuit, and then inverted with a...
This can work just fine: 1. Set up a timer interrupt at 10ms. Or even at 1ms and after ten int's do step 2. 2. Every interrupt read the buttons into the arrays. You can use a low priority...
I also found the MAX6818 debouncer, but it's $4.37 for 8-bit at JLCPCB. More like master of none. :wink:
Nice chip! I did not knew that one although I am of the CMOS era! Anyway, since you master the art of software, I think is waste of money to add hardware when you can debounce in software. ...
Yes, the Config block generated errors. Solved by writing : ASM __config _CONFIG1, _FOSC_INTOSC & _WDTE_OFF & _PWRTE_ON & _MCLRE_OFF & _CP_ON & _CPD_ON & _BOREN_OFF & _CLKOUTEN_OFF & _IESO_ON...
Those errors comes from using the wrong syntax for the CONFIG block. The example Ioannis posted compiles just fine.
Wow, I designed those into counting circuits about 45 years ago.....
Ads1115
hello!
DymDym Today, 14:09Does anyone have a working code for ads1115
(Proton PicBasic)...