lookdown2 Volt_humid, <[128,132,135,138,141,144,147,150,154,157,160_ ..............
is what i would use
The HIH-4000 Humidity Sensors has an output voltage which must be referenced to percent humidity. My DS2438 is reading the voltage output of the humidity sensor. I then need to use a lookdown table...
MOUNTAIN747 Today, 00:11I found out the hard way that not all HC-05 modules work the same. Use the version AT command and look for modules with the latest firmware versions. Try to establish a serial communication first...
rsocor01 - 31st March 2025, 12:48The new one is the BTN8982 and is only produced at TO263-7 package.
How do you solder this one on the PCB by hand?
Anyway, have ordered the board that you showed. Hope it is an old stock and...
You are right regarding the unknown chinese parts.
I tried to find the specific chip but seems it is too old and stopped production by Infineon.
Maybe they produce other, newer chips now. Have...
just a thought too..... it is a lot of technology for the price, but sometimes these types of things, probably from China don't meet expectations.... but sometimes they are good!!!
amgen - 31st March 2025, 00:13Wow!!! Amazing module! 40amps DC at 85 degrees? Can't believe it!
Many thanks for this.
Ioannis
there are a bunch of these types of things with your I and V range. Thats why I was wondering if your voltage was like 200+ volts or 50-80 amps.
.
.
9957
It will be between 20-25 Volts.
Load max 10-12Amps.
At low pusling frequencies, obviously the 19mH coil will be more like a low ohm resistor, so the current will be limited.
Ioannis
Re: Lookdown2 not working!
Thanks Richard, I'll give it a try. You got me! AF
MOUNTAIN747 Today, 03:36