It looks like you have a 16F1826 selected instead of 16F1827.
DaveP Today, 13:02Thank you ! Just tried ... What could cause these two errors?
fratello Today, 07:00Got this from AllAboutCircuits. First time I hear about a MC14490, Hex Contact Bounce Eliminator:
https://www.youtube.com/watch?v=BeFYsx6M3BM
Too bad it's in multiples of 6 pins. It would...
If you expect the signal to swing between 0 and +5V then set the trigger level to somewhere around 2.5V.
As with input coupling the trigger coupling can usually be set to either AC or DC. Perhaps...
Here are my settings. Use it as a starting point.
#config
__config _CONFIG1, _FOSC_INTOSC & _WDTE_ON & _PWRTE_ON & _MCLRE_OFF & _CP_OFF & _CPD_OFF & _BOREN_ON & _CLKOUTEN_OFF & _IESO_OFF &...
Wish you to enjoy your new toy!
Regarding the modes and trigger it is necessary to read the manual. Every scope may have its own quirks.
Nice buy, at a nice price.
The fast rotation of the...
I have it set at 4.9V along the right edge of the screen. That's exactly the thing that I haven't totally figured out yet. Sometimes it's there, sometimes it's not.
When nothing displays, I...
If you don't know, read up on what Auto/Normal/Single mode actually does. Also, there's no indication of trigger level on the scope screen, where do you have that set?
HenrikOlsson Yesterday, 07:10There's something hinky going on. Sometimes it won't scan the probes. I still haven't figured out what exactly.
But I go though the MODES, eventually the RUN/STOP buttons goes red, I reset it...
Qualifying Compiler |
Upgrade Description | |
Upgrade PICBASIC PRO (PBP) 2.60 or later to PBP3 Gold Edition | ||
|
||
|
||
Upgrade PICBASIC Compiler (PBC) to PBP3 Silver Edition |
Re: Scanning encoder debounce on new scope
Wow, I designed those into counting circuits about 45 years ago.....
DaveP Today, 13:04