If you expect the signal to swing between 0 and +5V then set the trigger level to somewhere around 2.5V.
As with input coupling the trigger coupling can usually be set to either AC or DC. Perhaps...
Here are my settings. Use it as a starting point.
#config
__config _CONFIG1, _FOSC_INTOSC & _WDTE_ON & _PWRTE_ON & _MCLRE_OFF & _CP_OFF & _CPD_OFF & _BOREN_ON & _CLKOUTEN_OFF & _IESO_OFF &...
Wish you to enjoy your new toy!
Regarding the modes and trigger it is necessary to read the manual. Every scope may have its own quirks.
Nice buy, at a nice price.
The fast rotation of the...
I have it set at 4.9V along the right edge of the screen. That's exactly the thing that I haven't totally figured out yet. Sometimes it's there, sometimes it's not.
When nothing displays, I...
If you don't know, read up on what Auto/Normal/Single mode actually does. Also, there's no indication of trigger level on the scope screen, where do you have that set?
HenrikOlsson Yesterday, 07:10There's something hinky going on. Sometimes it won't scan the probes. I still haven't figured out what exactly.
But I go though the MODES, eventually the RUN/STOP buttons goes red, I reset it...
Thanks! I thought of rechecking my stuff a Nth time yesterday and noticed the coupling too.
All is well in the world.
:biggrin:
9674
I'd be more worried by the fact that signal swings negative and not positive :-)
Don't worry though, it looks like you have the input coupling set to AC on the scope. Set it to DC and try again.
Hi all !
I have a montage where I use 16F628A I/P with the settings below. Due to the price that has increased a lot and the unavailability (is it an older generation?) I would like to switch to...
Qualifying Compiler |
Upgrade Description | |
Upgrade PICBASIC PRO (PBP) 2.60 or later to PBP3 Gold Edition | ||
|
||
|
||
Upgrade PICBASIC Compiler (PBC) to PBP3 Silver Edition |
Re: Scanning encoder debounce on new scope
Got this from AllAboutCircuits. First time I hear about a MC14490, Hex Contact Bounce Eliminator:
Demon Today, 04:26https://www.youtube.com/watch?v=BeFYsx6M3BM
Too bad it's in multiples of 6 pins. It would...