I was originally planning on making 2 sets of MCP23017 circuits; 1 for input with debounce, 1 for output. But even with JLCPCB it comes out to $1 / PCB. I'd like to lower my cost more, and not have...
Use a logical analyzer to see what's coming out of the chip. Compare the output of the SEROUT2 to the output of the HSEROUT2 using the logical analyzer. You might think that your output is 115200,...
I've set the hardware config totally manually from the datasheet and via PBP defines (suggested in the supplementary document PIC18FxxK42_notes) and many hybrids of the 2 methods.
You might want to double check that you are setting the hardware communication correctly. I have used the code below to set the HSEROUT/HSERIN for the 18F4550. You might want to check the correct...
Hi all,
Having issues transmitting numeric data out from the 18F26K83 using hserout. No problems with the software serout2, but for some reason all my numerical data is corrupted for hserout ie....
I have used hot glue before to secure a Dupont socket onto a header pin. But, even when I don't use the hot glue the connector never moves. Unless there is a lot of vibration, I don't think the glue...
Published on - 27th June 2012 15:31
Number of Views: 4390
Hi All!
Here is the code to create a voltmeter and ammeter. Everyone has a "display of choice" so you can use this to drive whatever display you wish to add. The color coding of the wires is only as a reference to make construction easier. I understand from Allegro that the ACS758 can handle as much as 200 amps and 72 amps is about maximum for this code. Hope this is of use and helpful to others.
Re: hserout issues on the 18F26K83
Again, if I have it set up as another baud rate, then why is every text string in quotation marks coming through fine?
rocket_troy Today, 23:08Troy