Hi,
Sorry for bringing back this old topic, but there seems to be a lot of knowledgeable users of these products. I've been looking at both the EasyPIC6 and QL200, and I have to say I'm leaning to the EasyPIC, mainly for support and documentation reasons. But I've had a hard time trying to determining a couple of things about it.

Firstly, is the MCU shown in the photos included, and what type is it? It doesn't seem to explicitly show this information on their site or in the documentation.

From what I've read, I can use MPLAB (and Hi-Tech C or Microchip C18, etc.). I usually use Pickit2 or 3 to program my PICs, but I assume the board will come with drivers for the mikroICD interface for MPLAB? I'm wrong on these points?

Also, will it only drive the MCU and peripherals at 5V, or can other voltages (eg. 3.3V) be used/selected?

Thanks in advance,
Angelo