button help

[Kalind]

think it will be easier to use 5 buttons instead of using a matrix keypad. How would I prompt the user to enter high and low setpoints immediately once the device is powered? With that, how would i configure a button to act as an "enter" button? The reason i ask this is because i want the program to ask the user to enter high setpoint then the user should press enter. The program should then ask the user to enter a low setpoint and pressing enter again will cause the program the jump to the main temperature display.

[skimask]

How would I.....
With that, how would i.....
i want...................
then ask......

Write some code...write some code...write some code. You have the PBP manual, you have internet access, you can search for methods on how to use BASIC, you can do almost anything, so, write some code. When that code that YOU write doesn't work, I'm sure a load of people here will help you troubleshoot that code to figure out why it doesn't work the way you want it to work. If you can't write the code, at least write out what you want to do on paper. Use a 'flowchart' type of setup. Just write it out. 'cause quite frankly, good luck finding somebody to write the code for you...

[Kalind]

skimask, you not obliged to reply. Keep your brilliance to yourself dude. You suck!

[skimask]

You suck!

That may be true. Some may even believe it. Here's the filename to my latest program:

What's the filename of your latest program?

[mackrackit]

Kalind,
Joe and I gave you some code to get started. Have you done anything with it?

In the mean time http://www.picbasic.co.uk/forum/show...6&postcount=13 then get back to us.