What, I restarted the computer after I installed everything!
I didnt install and directly started to use MCS+
|
What, I restarted the computer after I installed everything!
I didnt install and directly started to use MCS+
Last edited by xobx; - 12th July 2007 at 21:35.
|
Apparently not...Originally Posted by xobx
Restart it again. Maybe your PIC will program itself with the finished product.
|
Lets see..
EDIT: ..nope
Last edited by xobx; - 12th July 2007 at 22:28.
|
Wow!
I think this is the first time I have seen this kind of behavior here.
(or maybe I am just confussed? Would not be the first time!)
I did not think it existed on this forum. But I guess I was wrong.
You can bet dollars to donuts I will think twice (maybe three times) about my questions!
Good luck xobx. Hope you can figure it out! And PLEASE post what you find so all us Noobs know what happened!
Best,
Bill12780
|
Ask all the questions you want! I'm all over it...BUT...
Sometimes you just have to point out the blatantly obvious to some people, and sometimes people just don't give a person crap to work with...
"My car doesn't run right...What's wrong with it?"
How much information can you get out of that to help out with a fix?
|
Hi Xobx,
There's two buttons on MCS. The one you showed here in your conversation with Skimask was the "compile only". The button next to it is "compile and program". If you use the "compile only button, then you manually open your programmer software and load your .hex into the programmer and go from there. If you use "compile and program" then MCS will compile the program AND open your programmer with the current .hex program ready to go. AT least that's how my MCS is working.
HTH,
BobK
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks