real time clock

[shahidali55]

I'm using a 16F84A so there is no question of internal oscillator.
I tried several other things besides LCDOUT. Even FOR and WHILE statements take a lot o ftime to execute . . .
I used a external 32.768Khz oscillator.
Just to verify that the F84 was running at 32.768Khz, i tried a clock code on it and it does keep accurate time . . . down to a second a day.

[skimask]

I'm using a 16F84A so there is no question of internal oscillator. I tried several other things besides LCDOUT. Even FOR and WHILE statements take a lot o ftime to execute . . . I used a external 32.768Khz oscillator. Just to verify that the F84 was running at 32.768Khz, i tried a clock code on it and it does keep accurate time . . . down to a second a day.

If you're running 32.768khz, everything is going to take a lot longer to execute.
The clock is 32.768khz, but the PIC is only executing instructions at 8.192khz (Fosc/4), and if you're code has a lot of call's, gosub's, returns, anything that takes the code to 'somewhere else', it'll run half that fast again (4.096khz, Fosc/4 + one extra instruction for each 'somewhere else').

So, what are you asking? What's the point?

[shahidali55]

I think i'll stick to 4Mhz for now . . .

[[email protected]]

this is a very belated response to shahidali55.

I've added a tiny bit of code to "ds1302_user_interface.txt" to enable trickle charging. This is a small feat, but helped me understand how the register addressing and definitions are used.

edit: I'm using a 5v 0.47f supercap which doesn't need diodes or resistors, so "trickledef" below uses a bit sequence 1010 (for TCS) 00 (for DS) and 00 (for RS), see page 7 of the DS1302 datasheet for other options

cheers,
Tobie

==========================

'additional variables
writechrg var byte
tricklereg var byte
writechrg = $91 'Write Command for the trickle register
trickledef = $A0 'definition for a supercap which uses no diodes or resistors

' this goes in the "setup" subroutine, not as the statement first or last though
reg_adr = writechrg
outbyte = tricklereg
gosub w_out

[[email protected]]

hi,

here's a modified version with trickle charge enabled for a supercap. Note this includes no LCD interface.

A schematic is included in this pdf http://www.parallax.com/dl/appnt/jav2/appnote2.pdf

Here's a datasheet for the supercap, I used the 0.47f component: http://rocky.digikey.com/WebLib/Coop...capacitors.pdf

[thetrueman]

Hi Melanie,

I used your code MN1307.txt which is very good coded and easy to understand. I just want to add some alarm time. I know and did with some if...then...endif way.

Now simply it works on alarm set time but output (portb.7) blinks and do not High permanently. I tried to find some solution but it is very simple that there should not be any problem with if...then...endif. But I think it is somethink with hardware related.

Please help me in this regard because I must need this Alarm Clock. Thanks in anticipation.

Best Regards,

Shahzad

[shahidali55]

Thanks for the trickle charge routines Tobie . . .