I've searched but haven't found the answer. I have Linx TX and Linx RX modules from Rentron as seen HERE and HERE.

My question (problem) is that I can send to and from a 12F675 through Hyperterminal just fine. But when I connect the output of the PIC to the DATA in on the TX module and I connect the DATA out from the RX module to the serial in line going to Hyperterminal, all I am getting from the receiver is garbled characters, mostly boxes almost non-stop showing in Hyperterminal.

I do notice different characters when the PIC and Linx are actually transmitting and the TX is definitely working as I have a field strength meter next to it. I am using N2400.

So to sum it up, how do I get the receiver to receive the DATA and display in Hyperterminal ?

Thanks for any guidance with this !

Sam