LCD Reset Problem

[Bill Legge]

Joe S

Thanks very much, your tip worked

FLAGS=0 Did the trick.

I've looked up the note on FLAGS=0 in the LCDOUT command page of the PBP manual and don't understand how it works?

1. If I cycle the power to the PIC, without 'FLAGS=0' all is OK.
2. If I re-set I get the missing lines problem unless the statement 'FLAGS=0' is included.

I thought the PIC executed the same code on re-set as on power-up?

Whatever, you help is much appreciated.

Regards Bill Legge

[Archangel]

Joe S

Thanks very much, your tip worked

FLAGS=0 Did the trick.

I've looked up the note on FLAGS=0 in the LCDOUT command page of the PBP manual and don't understand how it works?

1. If I cycle the power to the PIC, without 'FLAGS=0' all is OK.
2. If I re-set I get the missing lines problem unless the statement 'FLAGS=0' is included.

I thought the PIC executed the same code on re-set as on power-up?

Whatever, you help is much appreciated.

Regards Bill Legge

It causes the LCD to reset each time the lcdout statement sends data to it.

[mister_e]

little deeper.... when you clear FLAGS value, the next LCDOUT will include the whole LCD initialization commands (1 line or more, 4 or 8 bits mode etc etc... see your LCD datasheet), then send your data.

You can do it manually with few LCDOUT, but since FLAGS-0 do the job, why messing with it euh?

[Archangel]

Just curious Bill, "reset" used in the first post, what do you mean by that, are you taking the mclr line low or doing a full power off scenario?
I ask because a power off that only browns out the LCD may be the entire problem. There will be times you do not want to use flags = 0 due to latency problems.

[Bill Legge]

Joe S

The boards I'm using have a 10k resistor that normally holds MCLR high. The re-set button takes the MCLR pin direct to ground. The power is on all the time.

I have been lazy with LCDs and not bothered with the spec sheets - just use the PBP LCD commands.

FLAGS=0 has solved most of my problems but I still get the odd occasion when alternate lines of the LCD don't come to life.

I suspect that the proper way to fix this is some combination of FLAGS and the configuration brown-out settings. AND READ THE SPEC SHEETS!

I mostly use PIC16F877A and PIC18F8722 chips on Mikroelektronika boards for developement and move to Futurlec boards for the end product - all hobby stuff, no production.

Thanks for you interest.

Regards Bill Legge