Servo reverse

[Acetronics2]

Hi,

First : Three big misunderstandings ...

1) LOW before PULSOUT is just to ensure the servo pulse will be positive. NEVER use "high" it could damage your servos ...

2) Servo positions ... 1000 µs is right, 1500 µs is centered, 2000 µs is left ( mainly - left and right can be inverted ) To change position, you must change pulse value ...

3) The Pulses MUST be sent regularly @ ~ 30-50 times per second. Even if the servo has to keep on its position.


Smooth movement will be chapter 2 ...

Alain

[Nicmus]

Hi bill_23,

Unless you are using a 4o MHz oscillator you might want to revise your PULSOUT statements. For 4 MHz your PULSOUT resolution will be 10 µs.

Also depending on your servos (90º, 120° or 180°) and the desired range of movement you might want to change the 1000-2000 µs window to a narrower one. Keep in mind your 1500 µs pulse will be your center.

Regards,

Nick

[tenaja]

3) The Pulses MUST be sent regularly @ ~ 30-50 times per second. Even if the servo has to keep on its position.

For clarification for the less experienced...

Alain is ONLY talking about old fashioned "cheap" analog servos. Most of the new digital servos (which aren't all that expensive, either) will accept a single pulse; they will go to that position and hold. I've used some in an application where the maintenance of an analog servo position was not practical.

[Acetronics2]

Hi, Tenaja

It can be a trick ... but here, it is not "genuine planned" : the servo, receiving no new pulse, keeps position as a Failsafe ...

Not all brands do that ... so, it must be checked before use ...

Alain

[bill_23]

Wow,
That was really simple, i was really getting hung up on this but i changed one side to 100 and one to 200 and it seems to work just how i want! This also got rid of the fidget in the opposite direction, except on a couple of the cheapo servos i am using but i just changed the 200 to a 190 and it stopped it from bouncing at the end.
Thank you all very much!
Now as far as Acetronics said

3) The Pulses MUST be sent regularly @ ~ 30-50 times per second. Even if the servo has to keep on its position.

If it works now should i change it? I am using very cheap ($3) servos, and some ones from parallax and i assume they are analog.
Thanks again

[Acetronics2]

Wow,
If it works now should i change it? I am using very cheap ($3) servos, and some ones from parallax and i assume they are analog.
Thanks again

Generally, if a µP program works as you expected ... Do not change anything until you have a VERY good reason to change it ...

AND Overall ... do not wipe off the first project until the new one has successfully passed ALL the "live" tests ...

Alain