Compare value ...

[richard]

guess its my fault , should have launched into defensive mode on first reply
like this
it looked too easy.

http://www.picbasic.co.uk/forum/showthread.php?t=24035

questions to ask

what have you tried ?
what are you measuring ?
where is your schematic ?
your code is incomplete what is in your config section ?
i see an incompletely described pgm with no config settings
in an unspecified circuit
no OSC statement in pbp code and still not a clue about the config settings used

it just occurred to me that the op may be a troll and we have just been played.
there is no way that the the op's code would ever have shown a realistic temp display with a lm335/lm235
because multiplying the reading with an offset would yield meaningless results.
it could have displayed a lm35 result as it was .
at no time did op ever say the displayed temp results were also wrong
i wonder.