ADCON1 settings 18F4620
Hello,
I want to set up 4 of the 13 availiable A2D converter pins on my 18F4620. Can someone clarrify for me......
If I want to set up AN0, AN1, AN4 & AN12 (8 bit resolution only) and leave every other pin on PORTA & B as digital input/ouputs.....
will this do the trick?
ADCON1.0=0
ADCON1.1=0
ADCON1.4=0
ADCON1.12=0
'tristates will already be defined above
Padawan-78
|
Nope, doesn't work that way.Originally Posted by earltyso
You can only have the analog ports the way the datasheet for the 18F4620 shows in DS39626B, page 224, under the heading Register 19-2.
As you'll see, ADCON only has 8 bits. ADCON1.12...not enough bits in ADCON for that.
Basically, you have to start at AN0 and add AN1, then AN2, then AN3, and so on until you get enough analog ports.
|
Thanks for the help, I have read the data sheet for using ADCON1, ADCON2 registers and I am still confused on how to use the table on page 226. Can you lend a hand.
I think I need to use ADCON2 to enable AN12.
Something like....
ADCON2.4 = 0 '????????
Padawan-78
|
Re-READ my post again...
Then Read the A/D chapter in the datasheet.
The ADCON registers don't work that way.
Question for you...
What does ADCON0 do?
What does ADCON1 do?
What does ADCON2 do?
Table on page 226? Which version of the datasheet do you have?
|
ADCON0 controls operation of A/D module
ADCON1 configs functions of port pins
ADCON2 configs A/D clock source
this is page 224 DS39626, page 226 in pdf view
Padawan-78
|
OK, here is what I do understand,
for ADCON1 control register.....I need...
bit 7 = 0
bit 6 = 0
bit 5 = 1 'I am using Vref- AN2
bit 4 = 1 ' I am using Vref+ AN3
what I still don't understand....from page 224
bit 3 = ?
bit 2 = ?
bit 1 = ?
bit 0 = ?
Padawan-78
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks