Quote Originally Posted by skimask View Post
But, be all that as it may be, it's nearly impossible to determine what the ECM will determine should be the NEXT pulse width. If it was me, I think I'd try a system that would LAG by one pulse event. Keep tabs on the previous pulse, modify that pulse width, shoot that pulse width on the next event, while at the same time, using a timer, measuring the current pulse width, while again, using a timer, to keep track of the current pulse width and stop it as required.
That was my initial thought too! But since I'm just coming out of the starting gate, I didn't know how that would be possible without a crystal ball. Thanks to some info I found on slick ways of using timers by DT, you're right, I think I will drop the notion of delaying the start of the pulse and keep tabs of the previous pulse to work off that.
This circuit will not be used blindly but in a monitored state on a dyno and is only the basis of the system. I know there are products out there for this but then there are also more than one type of shoes too.
Thanks for the confirmation!