Don't bother at Arrow / Verical. I cleaned them out.Originally Posted by rsocor01
Re: PIC16F1454 Connecting To USB Doesn't Work
Don't bother at Arrow / Verical. I cleaned them out.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Re: PIC16F1454 Connecting To USB Doesn't Work
I bought a few from Mouser. I'm hoping I can make the USB part work without any issues. I'll open a new thread if I have problems.
"No one is completely worthless. They can always serve as a bad example."
Anonymous
Re: PIC16F1454 Connecting To USB Doesn't Work
If not you, then most likely me.
Good for using Mouser, cause those on special at JLCPCB, it's the same units I bought. They just haven't updated their global stock yet.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Re: PIC16F1454 Connecting To USB Doesn't Work
The 18F13K50 won't compile with the DT interrupt file ReEnterPBP-18.bas. This variable HP_Vars is in the DT ReEnter interrupt file. If you want to use this interrupt, you need to go with the 18F14K50. The 18F14K50 compiled fine, but I haven't test it because I don't have one now. I need to order it. All the USB commands compiled fine.
"No one is completely worthless. They can always serve as a bad example."
Anonymous
Members who have read this thread : 13You do not have permission to view the list of names.
Posting Permissions
Reply With Quote
Bookmarks