Motor Stepper Example

[astanapane]

The motors are Brushless type and need a special High current driver (at least 30 Amps).

When a specific driver is selected we can see how to control it.

Ioannis

For my case i have selected the Dentrum 25A controller for the specific motor. IT works fine.

But i havent checked the input for the controller yet. And dont want to mess around a lot with it. The cost is not too high...about 20 euros.

[Ioannis]

I could not find any datasheet about the Dentrum, but I suppose it is a standard servo input controller.

If this is the case then it just needs pulses every 20ms and from 1 to 2ms wide.

Please confirm the input of the driver.

Ioannis

[Ioannis]

... The cost is not too high...about 20 euros.

Or less: http://www.hobbypartz.com/60p-dye-1002-25a-esc.html