Warning & Error Messages

[mackrackit]

Here's one that took me a while to figure out:
Warning is:
"Warning Line 23: Command line overrides statement. (18F4550.BAS)"
Solution was:
Change the compiler from PBPW to PBPL by: View->Compile and Program Options-> Compiler->Select Check Box by "Use PBPL".

What was the code number?

[cc1984]

What was the code number?

No code number is returned. I get exactly what I typed in. What category do these "non-assigned" error codes fall into? It is definitely a fatal error, since it will not compile.

[mackrackit]

No code number is returned. I get exactly what I typed in. What category do these "non-assigned" error codes fall into? It is definitely a fatal error, since it will not compile.

Interesting.

When I forget to use PBPL I get:
"....ERROR line 20: Bad data type."

That is with MCS. What are you using as a code editor/IDE?

[Demon]

Dave,

Does MPLAB give the same error messages than MCSP? Are there alternative IDEs?

I would think that error code numbers are IDE specific. Unless they all got together and came up with a standardized list, but that would surprise me greatly. It might be a good idea to separate the wiki by IDE product.

(I don't use MPLAB so can't comment on that)

[mackrackit]

Pic Basic Pro has codes of its own as MPASM does. The errors are saved to error files in your project directory. The IDE reads thos files.

As far as I know anyways.

[cc1984]

Interesting.

When I forget to use PBPL I get:
"....ERROR line 20: Bad data type."

That is with MCS. What are you using as a code editor/IDE?

I am using MicroCode Studio. What shipped on the PBP installation disk.