Gsm/Gps Tracker

[mackrackit]

What are the stop bits and parity of a phone?

[camolas]

What are the stop bits and parity of a phone?

Hi,

This is a nokia 6210 and works as 9600,8,N,1

Thanks

[mackrackit]

Have you tried connecting to a PC with a terminal program like the one in Micro Code Studio?

[aratti]

Camola, I am a little confuse. I did a bit of research on google and it seems that
nokia 6210 has a USB connection. Are you sure your phone has a serial connection?

Al.

[camolas]

Camola, I am a little confuse. I did a bit of research on google and it seems that
nokia 6210 has a USB connection. Are you sure your phone has a serial connection?

Al.

Hi,

Yes it have and there are nokia cables to conect it to pc rs232 i have one from nokia and works fine with hyperterminal.

Thanks

[camolas]

Have you tried connecting to a PC with a terminal program like the one in Micro Code Studio?

Hi,

I only try whit Hyperterminal with sucess.

Thanks

[mackrackit]

Hi,

I only try whit Hyperterminal with sucess.

Thanks

Then try SERIN2 in inverted mode for a test. Could be an external hardware problem?

[aratti]

Camola, from your code it seems that you are using portC.6 and PortC.7 for communication with cellphone. If this is correct then:

Connect pic portC.6 to max232 pin 11 (TTL Tx)
Connect pic portC.7 to max232 pin 12 (TTL Rx)
Connect max232 pin 14 to phone serial cable pin 3 (Should be Rx ?)
Connect max232 pin 13 to phone serial cable pin 2 (should be Tx ?)
Connect circuit ground to phone serial cable pin 5

(If you connect it to the PC I assume you have a 9 pins DB female connector)

It should work. If it doesn't invert connections at the serial cable pins 2 & 3

Al.

[camolas]

Camola, from your code it seems that you are using portC.6 and PortC.7 for communication with cellphone. If this is correct then:

Connect pic portC.6 to max232 pin 11 (TTL Tx)
Connect pic portC.7 to max232 pin 12 (TTL Rx)
Connect max232 pin 14 to phone serial cable pin 3 (Should be Rx ?)
Connect max232 pin 13 to phone serial cable pin 2 (should be Tx ?)
Connect circuit ground to phone serial cable pin 5

(If you connect it to the PC I assume you have a 9 pins DB female connector)

It should work. If it doesn't invert connections at the serial cable pins 2 & 3

Al.

Hi,

But is not need to give the nokia data cable any power?

Thanks

[camolas]

Then try SERIN2 in inverted mode for a test. Could be an external hardware problem?

Hi,

I have used Serin2 and works not in any 16f877a port it works on B.7 as Rx and in B.6 as Tx.

Serout2 PortB.6, 84,["AT",13,10]
Serin2 PortB.7,84, [wait ("ok")]
High PortB.0

Dont work in C.7 and C6, C4 and C5 big mess.....

Can i used 2 diferents Serin2 and Serout2 in same code because i need to control phone and gps i was using hserin/out to phone and Serin2/out2 for gps.

Thanks