assembly in Pic

[Ruben Pena]

Dear Julio:
Are you J.A.Sanchez from the Video stamp project in April 08 Circuit Cellar ?. If so..
I have several questions about the project:
I made a small PCB to mount the components, but I added a 4k7 resistor at the Mclr pin,
because I can not find where do you define the use of the internal reset.
It works since the first time,but I found comm errors in the transmited data... I will add
a 8MHZ resonator and will try again...(Note if I cut the Mclr resistor it stops working).
Also... when I programmed the original hex file with the USB Melabs Progremmer,the osc
fuse is configured as extrc. Any comments...?
My congratulations for this outstanding proyect.
PBP 2.5 MPLAB 8.02 PIC18F2520
Greetings...
Ruben de la Pena V.

[skimask]

Dear Julio:
Are you J.A.Sanchez from the Video stamp project in April 08 Circuit Cellar ?....

If you read a bit closer, you'll notice this in the very first post:

hello
Below is a program I have with the book I am reading. I am confused with the command to the lcd like ( INITIALIZE LCD PROCEDURE ):

As far as your config fuse issues, refer to posts #7 and #8 of:
http://www.picbasic.co.uk/forum/showthread.php?t=5777