assembly in Pic

[mister_e]

i knew he was an a s s h o l e but at that point

anyways, i think i may have a PDF copy of a OLD previous lessons of him.

I think i also have a copy of CEGEP du vieux Montreal lesson somewhere... I'll let you know if i find it.

[Acetronics2]

Hi, Ken

The site is only TEPORARILLY Shut Down ...

The fact is Bigo. didn't appreciate to get a TRUE "State Leader" ( Whether he is Socialist or Capitalist !!! ).

May be he could apply His shiny democracy lessons to himself ...

We just have to wait a moment for him to get out of Childhood ...

Alain

He's not the only " who knows" ( we've got TRENT here ...)

have a look here, in between :

http://www.hobbyprojects.com/microco...tutorials.html

P.S : I DO Have the 5+ Zip files on my HDD ... if really necessary.

[mister_e]

and while we're at it, MikroElektronika also do some kind of tutorial as well
http://www.mikroe.com/en/books/picbook/picbook.htm

untill Mr Bigonoff break his own stupid buble, the above is for sure a nice start point... but as Mr Bigonoff.. it's outdated. Bah, ASM is ASM.

[Ruben Pena]

Dear Julio:
Are you J.A.Sanchez from the Video stamp project in April 08 Circuit Cellar ?. If so..
I have several questions about the project:
I made a small PCB to mount the components, but I added a 4k7 resistor at the Mclr pin,
because I can not find where do you define the use of the internal reset.
It works since the first time,but I found comm errors in the transmited data... I will add
a 8MHZ resonator and will try again...(Note if I cut the Mclr resistor it stops working).
Also... when I programmed the original hex file with the USB Melabs Progremmer,the osc
fuse is configured as extrc. Any comments...?
My congratulations for this outstanding proyect.
PBP 2.5 MPLAB 8.02 PIC18F2520
Greetings...
Ruben de la Pena V.

[skimask]

Dear Julio:
Are you J.A.Sanchez from the Video stamp project in April 08 Circuit Cellar ?....

If you read a bit closer, you'll notice this in the very first post:

hello
Below is a program I have with the book I am reading. I am confused with the command to the lcd like ( INITIALIZE LCD PROCEDURE ):

As far as your config fuse issues, refer to posts #7 and #8 of:
http://www.picbasic.co.uk/forum/showthread.php?t=5777