Error programming 16F688

[manxman]

Thanks for the idea. I downloaded the patch program and ran it. However, the program replies:

"Nothing to do! The files are already updated."

So no solution I'm afraid!

[mackrackit]

Thanks for the idea. I downloaded the patch program and ran it. However, the program replies:

"Nothing to do! The files are already updated."

That is not the correct response. From melabs Software patch for PICBASIC PRO™ version 2.45.: http://www.melabs.com/support/patches.htm

If you try to patch an installation that has been patched previously, you will receive the error: "This program cannot update the installed version of PICBASIC PRO Compiler because of the following reasons: c:\pbp\PIC12F683.BAS: unknown version." If you see this, you don't need the patch.

Just an observation

[manxman]

Downloading this patch from Melabs and running it produces the same "Nothing to do" error message. I have had no problem compiling for other 16F*** and 18F*** PIC devices.

[Bruce]

Have you tried updating to the latest version of MicroCode Studio?

The 2.45 patch only works if you have a version of 2.45 that was
shipped before the update. You may have a version 2.45 that already
included the update, so the patch doesn't do anything.

I would try compiling from the command line too. That would at least
tell you if it's MCS or PBP.

[dhouston]

Is the 16F688 listed in the MCS drop-down combo box? If not and your version of PBP does support that chip, I think all you need to do is edit pic.ini which is in the folder where you installed MCS. That has worked for me in the past.

[manxman]

Yes, it is in the Microcode Studio combo box! I select this processor but the error appears!

[dhouston]

Yes, it is in the Microcode Studio combo box! I select this processor but the error appears!

Then I think you need a later version of PBP.