migrating to pic18f452 from 16f877a

[tamersoss]

Dear melanie .... i will try your suggestion ... i saw this table and i wondered why 40 mhz is not included ... you explained it ... the datasheet says at the very begining that max freq. is 40 mhz (not max external oscillator frequency) ... i will try and let you know the result ... however , many thanks for your kind concern.

[skimask]

Dear melanie .... i will try your suggestion ... i saw this table and i wondered why 40 mhz is not included ... you explained it ... the datasheet says at the very begining that max freq. is 40 mhz (not max external oscillator frequency) ... i will try and let you know the result ... however , many thanks for your kind concern.

It's probably not the PIC's fault that it won't run at 40Mhz, it's probably the circuit board's fault. The PIC will run all day at 40Mhz (55Mhz for one of mine that I pushed up a bit) even with an external 40Mhz. The key is a well designed 40Mhz external oscillator. There's a dozen reasons why a 40Mhz crystal won't run if it's not built right, especially if you're using one of those plastic solderless breadboards. Besides that, the external 10Mhz will keep down EMI over the whole circuit board.

[Melanie]

Are you saying that you've actually had a 40MHz xtal or resonator directly work with one of these (18Fxx2) PICs (which would contradict the maximum Datasheet figures)?

[skimask]

Are you saying that you've actually had a 40MHz xtal or resonator directly work with one of these (18Fxx2) PICs (which would contradict the maximum Datasheet figures)?

Yep, 40Mhz Xtal w/ 33pf cap's right next to OSC1&2 with a bit of a ground plane around the whole thing. Wasn't too reliable though. I'd touch practically anywhere the board and the PIC would lock up. That's when I read the rest of the datasheet (DS39564C) and found what you were saying about the 25Mhz earlier and fixed the whole thing.

As far as the 55Mhz goes, that was a 13.824Mhz oscillator, and using the 4xPLL, but that was also running the chip on 6.5v.

And this was the same chip that did 40Mhz with the external crystal. My guess is that this particular 18F452 chip was 'perfect', if not better, from the factory...a once in a lifetime good deal for me...not the norm obviously...

[sougata]

Hi,

Almost all of my 18F452 designs are based on x4 PLL mode. That is I use a 10MHz crystal and get a 40MHz Fosc. They have never let me down.