Long start time

[ttease]

Thanks for the links and info.

Okay, I read the threads suggested and I'm more confused than before but I believe I have the bits set. I checked by importing the *.asm file into MPLab ver 7.52 and looked at the 'configuration bit' and they are set as I wanted.

I got this working by modifing the 18f4431.inc file to this:

; __CONFIG _CONFIG1H, _OSC_XT_1H
; __CONFIG _CONFIG2H, _WDTEN_ON_2H & _WDPS_128_2H
__CONFIG _CONFIG1H, _OSC_IRCIO_1H
__CONFIG _CONFIG2H, _WDTEN_OFF_2H & _WDPS_128_2H
__CONFIG _CONFIG4L, _LVP_OFF_4L

My question now is what is the current way of setting these bits. These threads as ~ a year old and I'm not sure which way to go with the '__config' being replaced by 'CONFIG' so I comment all the '__CONFIG' lines out and added:

CONFIG OSC=IRC,WDTEN=ON,WDPS=128,LVP=OFF

Is there a better way to do this? Can I add it to the *.bas file?

[skimask]

Thanks for the links and info.

Okay, I read the threads suggested and I'm more confused than before but I believe I have the bits set. I checked by importing the *.asm file into MPLab ver 7.52 and looked at the 'configuration bit' and they are set as I wanted.

I got this working by modifing the 18f4431.inc file to this:

; __CONFIG _CONFIG1H, _OSC_XT_1H
; __CONFIG _CONFIG2H, _WDTEN_ON_2H & _WDPS_128_2H
__CONFIG _CONFIG1H, _OSC_IRCIO_1H
__CONFIG _CONFIG2H, _WDTEN_OFF_2H & _WDPS_128_2H
__CONFIG _CONFIG4L, _LVP_OFF_4L

My question now is what is the current way of setting these bits. These threads as ~ a year old and I'm not sure which way to go with the '__config' being replaced by 'CONFIG' so I comment all the '__CONFIG' lines out and added:

CONFIG OSC=IRC,WDTEN=ON,WDPS=128,LVP=OFF

Is there a better way to do this? Can I add it to the *.bas file?

You can make those changes 'permanent' by changing the correct .inc file for whatever specific processor you're using. But you have to watch it. If you want something different for that same processor type on a different project, you'll have to change the .inc file again.
Maybe you could "include" a seperate file that has all of those settings in it...i.e. include "normal.bas" or include "special.bas" and each of those .bas file would have all of you config settings in it, without all of the extra lines to worry about. Then they'd be 'permanent'.