I'd be more worried by the fact that signal swings negative and not positive :-)
Don't worry though, it looks like you have the input coupling set to AC on the scope. Set it to DC and try again.
|
Re: Scanning encoder debounce on new scope
I'd be more worried by the fact that signal swings negative and not positive :-)
Don't worry though, it looks like you have the input coupling set to AC on the scope. Set it to DC and try again.
|
Re: Scanning encoder debounce on new scope
Thanks! I thought of rechecking my stuff a Nth time yesterday and noticed the coupling too.Originally Posted by HenrikOlsson
All is well in the world.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: Scanning encoder debounce on new scope
Got this from AllAboutCircuits. First time I hear about a MC14490, Hex Contact Bounce Eliminator:
Too bad it's in multiples of 6 pins. It would be perfect if it was 8; that way I could have 2 ICs running alongside MCP23017 I/O Expanders with no waste.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks