16 bit PWM using CCP1

[richard]

your version cannot work since CCP1CON and CCPR1H are not in bank 0

and yes the code you marked red serves no purpose in the given example

[EarlyBird2]

your version cannot work since CCP1CON and CCPR1H are not in bank 0

and yes the code you marked red serves no purpose in the given example

My point was that the code in red stopped it working and I could not work out why it was there.

[talatsahim]

your version cannot work since CCP1CON and CCPR1H are not in bank 0

and yes the code you marked red serves no purpose in the given example

Richard,
Thanks for your reply.
Yes, you're right. 103 error occurs after compiling. Banksel command is used, will you?

Talat

[talatsahim]

I installed the PBP trial version 3.0.7 to try. Nothing's changed. Error 113 continues (Post 56, I wrote 103, it's wrong)

[HenrikOlsson]

Hi,
Check your spelling of CCPR1H and CCPR1L.

/Henrik.

[talatsahim]

Hi,
Henrik, congratulations for being careful, thank you.
This is a completely copy-paste disaster
Talat

[EarlyBird2]

Hi,
Henrik, congratulations for being careful, thank you.
This is a completely copy-paste disaster
Talat

That error comes from post #35 and #37 is there anyway these posts can be corrected?