Select Case range of values

[sayzer]

A <font color="#000080"><b>VAR BYTE




SELECT CASE </b></font>A


    <font color="#000080"><b>CASE IS </b></font>&gt; <font color="#FF0000">5 </font><font color="#000080"><b>AND IS </b></font>&lt; <font color="#FF0000">20
        </font><font color="#000080"><i>' do your stuff...
    </i><b>CASE IS </b></font>&lt; <font color="#FF0000">40 </font><font color="#000080"><b>AND NOT </b></font><font color="#FF0000">35
            </font><font color="#000080"><i>' do your stuff...
</i><b>END SELECT



</b></font>

[Darrel Taylor]

<font color="#000080"><b>CASE IS </b></font>&gt; <font color="#FF0000">5 </font><font color="#000080"><b>AND IS </b></font>&lt; <font color="#FF0000">20
</font>

That's what I thought too. &nbsp; But when I tried it in a test program, it didn't work.
It's not in the manual, even though it compiles without warnings. &nbsp; So I wasn't sure if it was valid.

I asked meLabs, and they said ...
"SELECT CASE isn't capable of logic in the cases. Never has been."

Is there a workaround, short of building a long CASE staircase?

I quess you'll need to use IF statements instead of SELECT CASE.

IF (A >= 5) AND (A <= 20) THEN
    ; something
ELSE
    IF (A > 20) AND (A <= 40) THEN
         ; something else
    ENDIF
ENDIF

[Acetronics2]

Hi,

A VAR BYTE

SELECT CASE A


    CASE IS > 5 AND IS < 20
        ' do your stuff...
    CASE IS < 40 AND NOT 35
            ' do your stuff...
END SELECT

could be Written

SELECT CASE A

    CASE IS <= 5 

    CASE IS < 20
        LCDOUT $FE,2, " < 20 " , DEC3 A
        
    CASE 35

    CASE IS < 40
        LCDOUT $FE,2, " < 40 " , DEC3 A

   CASE ELSE

END SELECT

CASE A left "blank" works fine...

Alain