LCD and 16F88

[G-R-C]

Hi All
I'm happy to say my LCD is up and running. I'm impressed by the number of
quick responses to my question.

Thanks to all for the replies and tips. You guys are great.
Gordon

[mister_e]

You're welcome!

You guys are great.

Yeah we know

Just to satisfy my own curiosity... what was the problem???

[G-R-C]

The problem was a couple of issues. The port wasn't set to digtal (ANSEL),
Another was the pull-up resistor was omitted. I checked the data sheet
to make sure the CMCON was turned off, but somehow didn't realize the
ANSEL register needed to be set to 0. Bet I wont forget about this register
in the furture.

Thanks again all.
Gordon

[mister_e]

Just to set the record. For this device and by the datasheet, PORTA.4 is not an open drain as some suggested. It's really a full CMOS output pin. So you don't even need the pull-up resistor.

But YES, you have to disable the internal analog comparators and ADCs.

Bet I wont forget about this register

Learning opportunity

[Archangel]

Just to set the record. For this device and by the datasheet, PORTA.4 is not an open drain as some suggested. It's really a full CMOS output pin. So you don't even need the pull-up resistor.

But YES, you have to disable the internal analog comparators and ADCs.


Learning opportunity

For the record, I checked the data sheet before telling him to put in ANSEL and is why I did not say to use pullup, and for the record I was surprised it did not need one.

[mister_e]

For the record , i was refering to post #7

But i have to agree, many pin have an open-drain output on this pin.

[savnik]

For the record , i was refering to post #7

But i have to agree, many pin have an open-drain output on this pin.

A half mistake. I learn from my error.