What is the difference between MCLR and switching VDD OFF-ON?

[Ioannis]

Why use a 555 and not directly connect the pushbutton to the /MCLR?

Ioannis

[Demon]

Why use a 555 and not directly connect the pushbutton to the /MCLR?

Ioannis

That was my plan. I've been doing that since forever, and it's only now causing problems.

I'm "guessing" it's because I'm using more and more peripherals in the PICs (timers, Interrupts, ADC, PWM, things I didn't really use much). I'm now using a lot more registers, and I'm guessing some of them are easily offended.

[Demon]

10uF and 100K generate a pulse of 1.1 seconds; should be enough for a complete reset of all ICs.

https://www.allaboutcircuits.com/too...table-circuit/

[amgen]

one thing that can happen is if you have any +5 volt on any of the peripheral pins, the input to the pins inside the PIC have diodes pointing to the supply voltage and then that 'could' keep the pic from resetting..... then, I don't know what..... maybe back to software instruction to reset....@RESET. Or if you take away/turn off power, would have to turn off the power for all external parts

[Demon]

I'm already using IRFZ44N power mosfets to power some sub-circuits. It's plenty strong to withstand whatever I throw at it.

I was thinking of using a 7404 inverter to get the signal the right way (this mosfet wants LOW to be OFF, the pulse from 555 will be HIGH).

[Demon]

one thing that can happen is if you have any +5 volt on any of the peripheral pins, the input to the pins inside the PIC have diodes pointing to the supply voltage and then that 'could' keep the pic from resetting.....

That is very possible.

This reset issue has cost me several days easily, I remember many frantic hours since I'm testing ADC/Timer/HPWM logic, not understanding why the simplest code mods were not taking; slapping LATB.x diagnostic signals all over the place and watching the Saleae window. I'm just happy I wasn't a complete doorknob all that time.

..... maybe back to software instruction to reset....@RESET. Or if you take away/turn off power, would have to turn off the power for all external parts

Nah, I like bulletproof solutions, even if they heavy-handed. Guess what band I got my online nickname from.


I'm really liking this 555 timer, 7404 inverter, IRFZ44N mosfet idea (mostly cause I thought it up on my own, and I've never used 555 and 7404 ICs before).

Unless you see a fault in my idea?

[Ioannis]

If you have a case like what amgen described, you better have a power cycle. This could be a relay, power MosFet, or a simple enable/disable of the power supply chip, etc.

Ioannis

[Demon]

Got a complete system reset working with a 555 timer, 7404 inverter and IRFZ44N mosfet:

https://www.picbasic.co.uk/forum/sho...426#post156426