Resetting a slave from master mcu

[Demon]

crap, I figured you were a kid .....

I'm a kid at heart, and I get out of bed at the same speed as them.

..... I always put the pics in sockets, saves a lot of F-ups....

Yeah, I'd hate to notice a mistake at the end of assembling my boards.

... For transistor, logic level MOSFET is good to use. The logic level means it will be full on with 5 volts on gate, no resistors required.... N-channel like BS170 ... with this, the reset is a high pulse on master...(dah)

I finally got a few SN7407 thanks to Mr E's suggestion a while back. This runs awesome, and I have room for 6 slaves, that should be enough for my boards.




I don't have to worry about the surges up towards the Master during programming the Slave.

(Which is good, cause my MeLabs U2 programmer doesn't do LVP, and I can't get my PicKit4 to run properly).