Hi I finally got it to compile. Now I have a small problem writing to memory. Its actually not writing. and on the LCD its always showing 0000
I have A0 and A1 to ground and A2 to 5v. on the eeprom 24LC1025, pins are configued correctly, is there anything in the program that will not allow a writing ???


Code:
'/////////////////////////
'// EEPROM  test program
'//	Using the PIC16F887
'//
'/////////////////////////

'/////////////////////////
'// Define section //
'/////////////////////////

'@ __config _CONFIG1, _INTRC_OSC_NOCLKOUT & _WDT_ON & _MCLRE_OFF & _LVP_OFF & _CP_OFF
'OSCCON = %01110000 '8 Mhz
DEFINE OSC 8
ANSELH = 0

'/////////////////////////
'// LCD configuration //
'/////////////////////////

DEFINE LCD_DREG PORTB 	' Set LCD Data port
DEFINE LCD_DBIT 4 		' Set starting Data bit (0 or 4) if 4-bit bus  RB.4, RB.5, RB.6, RB.7
DEFINE LCD_RSREG PORTB 	' Set LCD Register Select port
DEFINE LCD_RSBIT 1 		' Set LCD Register Select bit
DEFINE LCD_EREG PORTB	' Set LCD Enable port
DEFINE LCD_EBIT 0 		' Set LCD Enable bit
DEFINE LCD_BITS 4 		' Set LCD bus size (4 or 8 bits) '4 therefore put wire at 4, 5, 6 and 7 of LCD
DEFINE LCD_LINES 2 		' Set number of lines on LCD
DEFINE LCD_COMMANDUS 2500
DEFINE LCD_DATAUS 250
DEFINE CHAR_PACING 2000
pause 1000

'/////////////////////////
'// PIN configuration //
'/////////////////////////

TRISB = %00000000 ' Set PORTB to all output
TRISA = %11111111 ' Set PORTA to all input
TRISC = %11000000 ' Set PORTC to all output


'///////////////////////////////////////////////
'// Variable Declaration and initialization //
'///////////////////////////////////////////////

Battery_Switch var byte
i var byte
j var byte
Battery_Charge_Counter var byte


SDApin var PORTC.4                     ' RTC data 
SCLpin var PORTC.3                     ' RTC clock
bat var byte
Write_Address var byte

RTCSec var byte :RTCMin var byte :RTCHour var byte :RTCWDay var byte :RTCDay var byte :RTCMonth var byte :RTCYear var byte :RTCCtrl var byte 


lcdout $FE,1, "Bienvenue"
lcdout $FE,$C0, "Welcome" 
pause 1500

I2CWRITE SDApin,SCLpin,$A0,$00,[$03,$02,$05,$00,$00,$00,$00,$00] ' Write to  memory
   pause 20
   


'////////////////////////////////////////////////////
'////////////////// PROGRAM /////////////////////////
'////////////////////////////////////////////////////

Mainloop:

	lcdout $FE,1, "Appuye sur Record"
	lcdout $FE,$C0, "ou sur Show"
	pause 200
	

 
if PORTC.7 =0 then      'always 5v, push button to gnd
			j=1

			I2CRead SDApin,SCLpin,$A0,$00,[RTCSec,RTCMin,RTCHour,RTCDay]
			lcdout $FE,1, "  Time ", dec j
			lcdout $FE,$C0, dec RTCDay, dec RTCHour, dec RTCMin, dec RTCSec
			pause 2000

Endif
			
goto Mainloop
End