Quote Originally Posted by Acetronics View Post
Hi, Mark

I do not think PBP can directly do what you are expecting ...

you should have a closer read of the ADC chapter of your datasheet and , after , drive the relevant registers ...
that are somewhat more numerous than those driven by a classical Adcin PBP command.

You'll also note there are fixed input groups, and Channel 0 + Channel 1 is not a valid group ...

PBP doesn't do everything for you, in short terms ...

Alain
Hi Alain,

Thanks for your reply. Yes I concluded last night that adcin would not work, but was
hoping otherwise!
Most likely will need a routine to set the group, channel, GO/DONE and store results on each read.

Regards
Mark