Has anyone got the bolt 18f2550 project kit working with PB3
Including the LCD display ?
Can't get the display working at all ? ...
Printable View
Has anyone got the bolt 18f2550 project kit working with PB3
Including the LCD display ?
Can't get the display working at all ? ...
What I found is the PB2.6 and earlier versions and using some LCDs, PB is too fast (20m xtal) in the initialisation routine for the LCD, and I have had to edit the appropriate file and insert some NOPs, doing this and the LCDs work fine.
Before any suggests to use the LCD US defines, these did not appear to work during the initialisation routine, they appear to only come in to effect later. There was a post recently about LCDs if I remember and that also had avice about editing the file. I assume that PB3 has the same routines.
thank you,
started to change some of the define lcd command times and it almost works but still not quite
thanks for the reply using PB3 so will look into it, thanks again
regards
leighton
Hi Leightonh,
I have the Bolt 2550 and would like to program it with PicBasic and use the Bolt 2550 boot-loader. How did you set this up?
Thanks.