Interrupts 101

Hello everyone. I am having a bit of a problem, this code (or it's equivalent) works merrily on assembler, but it seems to lose the declarations for the ports after if executes the interrupt routine.
Can anyone tell me what I am doing wrong? This code works ok, but as soon as it hits the asm routine, it stops working. The interrupt works, the sequence works, values are sent to the variable portc.3 but the port does not respond. Even if I use "portc.3" instead for led4, it does not respond.

Thanks for your help

(at 4Mhz, there would be 234375 interrupts per minute, roughly 1500 interrupts per half a second)

Somehow, I doubt it is this easy, but... what is the square on BCF IN "square" TCON,2 ???

Code:

---

; Insert interrupt code here
        bsf          _myflag               
      movf psave, W
            movwf PCLATH
        swapf ssave, W
        movwf STATUS
            swapf wsave, F
        swapf wsave, W
        bcf    IN 
TCON,2
        bsf    INTCON      ,7
      retfie ; Return from      rupt
endasm

---

I will have to revise that code, it was written on a PC, and copied to a MAC via USB thumbdrive, something got garbled in the way.
The program was tested in MPLAB, the sequences work as expected, just the ports don't respond, or only some bits respond. It is not an MPLAB issue either, because a programmed chip does the same.
Thanks