PlantBob
- 19th January 2011, 14:04
Is there a minimum time value for the PAUSE statement? I know you have to set the OSC speed but the PAUSE values are way off.
PlantBob
- 19th January 2011, 14:15
PAUSE 100 in my code is about 100 seconds PIC18F2450
cncmachineguy
- 19th January 2011, 14:17
I think the minimum for PAUSE is 1mS, shorter pauses should use PAUSEUS.
There are up to 3 things to verify for the pause to work correctly.
DEFINE OSC - Used to tell PBP what speed to use for calculating PAUSE,SERIN/OUT, and so forth
OSCCON - Depending on the PIC used, this is to set the PIC to the desired speed
In the config settings, internal or external OSC.
If using INTERNAL OSC, verify default speed.
Powered by vBulletin® Version 4.1.7 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.