Quote Originally Posted by Darrel Taylor View Post
OK, I'll put a blinky on RA2.
Give me some time to modify and test.
Thank you
In the mean time.
1. Check the voltage on pin 18 Vusb. It should be ~3.3V.
USB ON MY PIC HAVE TO BE BROKEN!
There (pin 18) is a voltage that is about 10mV without the cable connected and something over 40mV with cable connected, however that value seems to grow slowly, maybe 10mV in 20sec.

2. D+ uses the internal pull-up to signify FULL speed operation. You should see around 2.8-3.3 volts on pin 24. If not, disconnect the USB cable, and check again.
Well, do not see that as could be guessed... it is broken, I can see on pin 24 (D+) something around 100-200mV

3. Try plugging another USB device into that USB port on the computer or hub. Make sure the port itself is working.
Yes, all ports work as they should. I can change devices from one port to an other without any problems etc.