Quote Originally Posted by Darrel Taylor View Post
That's not good.
They are a differential pair. So when one is high, the other is low.
You should never see both low.
Yes, of course... however they still are both "down" so probably the USB portion of my PIC is broken. How has that happen, can not tell, don't know but that seems to be the case. Have to wait for Monday to get a new PIC.

Oh, and according to the PCB layout, the B-type connector is wired to the SN65220 correctly, and the pinout is right. But is was a pretty small portion. Hard to tell where the traces go from there.
Everything is ok there, that picture was just for showing the connector. As said earlier, if Eagle says that the board and schematic are consistent then there really can't be such errors. Have measured all traces, they go where they should go and they are not broken either and they are not too close each others either.

Could it be possible that the PIC would have been "broken" when bought? I could not think so, but on the other hand Murphy's law says something else...