Hello

But, if the chip was blown the program that is on it wouldn't work? Or am I wrong? I can run the program that is on the chip that I can't erase.

When I tries to erase/reprogram the chip with "ProgPIC2" the program answer that there are no chip connected. The same happens with the other chip (the one that workes) as soon as I programmed it. But after I erased it with "IC Prog" I could reprogram it again. And when I did reprogram it again the same message appears. I know that the chip is connected and that isn't loose.

I have also tried another power supply. It didn't work.

\Jonas
http://www.geocities.com/jcee324