How to transfer data from 3 micro to 1

[Darrel Taylor]

Hey, D_T!!! Could I hotlink your ROFL.GIF here?

You could, I don't mind. But it wouldn't be very nice to laugh at him.

amindzo,

Without more information, all I can say is ... RS485, 1 master/3 slave.
<br>

[Archangel]

Hi amindzo,
look at this link, I bought several of this authors books, and would again.
http://www.lvr.com/serport.htm#my_example_code

[amindzo]

Hi,my friend suggest that you use a multi cable to connect one port to another port of main micro(8 wire,for example PORTB of micro 1 to PORTC of main micro) and use PEEK and POKE instruction. you put one byte on a port and read it from main micro and you should make a time program to read data on time.
but it is not a good method. it's need a lot of wire and the distance can effect on the voltage,current and also we have noise.

[skimask]

Hi,my friend suggest that you use a multi cable to connect one port to another port of main micro(8 wire,for example PORTB of micro 1 to PORTC of main micro) and use PEEK and POKE instruction. you put one byte on a port and read it from main micro and you should make a time program to read data on time.
but it is not a good method. it's need a lot of wire and the distance can effect on the voltage,current and also we have noise.

See Post #3!

[amindzo]

what about using serin and serout instructions and a shield cable?

[skimask]

what about using serin and serout instructions and a shield cable?

That'll work great...

http://en.wikipedia.org/wiki/EIA-485

[amindzo]

if i want to use serin and serout instructions, can i connect(for example) PORTB.0 of micro 1 to PORTC.1 of main micro with wire directly?(with 10 to 20 meter distance)