18F4620 Fuses configuration

[Pic2008]

You can use back the previous code. Just replace pic16F628a with pic18F4620.

[Bruce]

See this thread http://www.picbasic.co.uk/forum/showthread.php?t=543

[Melanie]

Not quite right Pic2008...

18F PICs require you to use the MPASM Assembler... and MPASM does not recognise the @ DEVICE syntax that configures the Config Fuses in the same way that the default PM Assembler does. Here is an example for a PIC18F2420...

	'
	'	PIC Defines for PIC18F2420
	'	==========================

	@ __CONFIG    _CONFIG1H, _IESO_OFF_1H & _FCMEN_OFF_1H & _OSC_XT_1H
							' Oscillator Switch-over Disabled
							' Fail-Safe clock Monitor Disabled
							' Set for external XT Oscillator RA6 & RA7 disabled
	@ __CONFIG    _CONFIG2L, _BOREN_OFF_2L & _PWRT_ON_2L & _BORV_0_2L
							' Brown-Out Reset Enabled
							' Power-On Timer Enabled
							' Brown-Out Trip set to 4.2v
        @ __CONFIG    _CONFIG2H, _WDT_ON_2H & _WDTPS_128_2H
							' WatchDog is ON
							' Watchdog Postscaler set to 1:128
	@ __CONFIG    _CONFIG3H, _MCLRE_ON_3H & _PBADEN_OFF_3H & _CCP2MX_PORTC_3H
							' MCLR is ON (external) PortE.3 is DISABLED
							' PortB 4:0 is digital on Reset
							' CCP2 is Multiplexed with PortC.1
        @ __CONFIG    _CONFIG4L, _STVREN_ON_4L & _XINST_OFF_4L & _LVP_OFF_4L & _DEBUG_OFF_4L
							' Stack Under/Overflow will Reset System
							' Enhanced CPU Addressing Disabled
							' Low-Voltage Programming is OFF
							' DEBUG is Disabled
	@ __CONFIG    _CONFIG5L, _CP1_ON_5L & _CP0_ON_5L
							' All Code Protect
        @ __CONFIG    _CONFIG5H, _CPB_ON_5H & _CPD_ON_5H
							' EEPROM is Code Protected
							' Boot Block code is Code Protected